- Home
- Category
- Civil Engineering Mcqs
- Building Materials & Construction Mcqs
- Building Materials & Construction Mcqs - Set 7
MCQs 1: The vertical distance between the springing line and highest point of the innercurve of an arch is known as______________?
MCQs 2: The type of arch generally constructed over a wooden lintel or over a flat arch for the purpose of carrying the load of the wall above is_______________?
MCQs 3: The triangular space formed between the extrados and the horizontal line drawn through the crown of an arch is known as_____________________?
MCQs 4: In the construction of arches, sand box method is used for________________?
MCQs 5: The type of roof suitable in plains where rainfall is meagre and temperature is high is______________?
MCQs 6: The lintels are preferred to arches because______________?




MCQs 7: The type of joint commonly used at the junction of a principal rafter and tie beam in timber trussess is__________________?
MCQs 8: The type of roof which slopes in two directions with a break in the slope on each side is known as_____________?
MCQs 9: The horizontal timber piece provided at the apex of a roof truss which supports the common rafter is called______________?
MCQs 10: Pitched and sloping roofs are suitable for________________?
MCQs 11: Mansard roof is a roof which slopes in________________?




MCQs 12: The lower edge of the pitched roof, from where the rain water of the roof surface drops down, is known as______________?
MCQs 13: Couple close roof is suitable for maximum span of________________?
MCQs 14: Higher pitch of the roof (1) results in stronger roof (2) results in weaker roof (3) requires more covering material (4) requires less covering material The correct answer is___________?
MCQs 15: The function of cleats in a roof truss is______________?




MCQs 16: Couple close roof is suitable for maximum span of______________?
MCQs 17: The function of king post in a king post roof truss is_______________?




MCQs 18: In any good staircase, the maximum and minimum pitch respectively should be_____________?
MCQs 19: Sum of tread and rise must lie between_______________?
MCQs 20: The maximum number of steps in a flight should generally be restricted to______________?
- Airport Engineering Mcqs
- Applied Mechanics & Graphic Statics Mcqs
- Building Materials & Construction Mcqs
- Construction Planning & Management Mcqs
- Design of Concrete Structures Mcqs
- Design of Masonry Structures Mcqs
- Design of Steel Structures Mcqs
- Dock & Harbor Engineering Mcqs
- Elements of Remote Sensing Mcqs
- Engineering Economy Mcqs
- Environmental Engineering Mcqs
- Estimating & Costing Mcqs
- Fluid Mechanics Mcqs
- Highway Engineering Mcqs
- Hydraulics & Fluid Mechanics Mcqs
- Irrigation, Water Resources Engineering & Hydrology Mcqs
- Railway Engineering Mcqs
- RCC Structures Design Mcqs
- Soil Mechanics & Foundation Engineering Mcqs
- Strength of Materials Mcqs
- Structural Analysis Mcqs
- Structural Design Specifications Mcqs
- Surveying Mcqs
- Theory of Structures Mcqs
- Tunnel Engineering Mcqs
- Waste Water Engineering Mcqs
ABOUT US
Category
Who We Are
TasDia Network, this platform not only provides you the best educational stuff but besides this, we are creating thousands of new ideas to making your signature and planning much more on a single platform.
All rights of the publication are reserved by tasdia.com.