MCQs 1: In a low power factor wattmeter the compensating coil is connected_______________?

MCQs 2: An induction wattmeter can be used for_________________?

MCQs 3: A dynamometer wattmeter can be used for______________?

MCQs 4: The multiplier and the meter coil in a voltmeter are in________________?

MCQs 5: For measuring current at high frequency we should use_______________?

MCQs 6: The pressure coil of a wattmeter should be connected on the supply side of the current coil when______________?

MCQs 7: The adjustment of position of shading bands, in an energy meter is done to provide______________?

MCQs 8: For measuring a very high resistance we should use_______________?

MCQs 9: The operating voltage of a meggar is about_______________?

MCQs 10: When a capacitor was connected to the terminal of ohmmeter, the pointer indicated a low resistance initially and then slowly came to infinity position. This shows that capacitor is____________?

MCQs 11: In order to achieve high accuracy, the slide wire of a potentiometer should be_______________?

MCQs 12: A direct current can be measured by________________?

MCQs 13: Which of the following devices should be used for accurate measurement of low D.C. voltage ?

MCQs 14: To measure a resistance with the help of a potentiometer it is_________________?

MCQs 15: The electrical power to a meggar is provided by________________?

MCQs 16: It is required to measure the true open circuit e.m.f. of a battery. The best device is_____________?

MCQs 17: An ohmmeter is a____________?

MCQs 18: Murray loop test can be used for location of________________?

MCQs 19: In a 3-phase power measurement by two wattmeter method, both the watt meters had identical readings. The power factor of the load was___________?

MCQs 20: Which of the following is an essential part of a motor meter ?